Pre-Flight Check List
Done One Day Before Launch. 

1.   ____Unload the Rocket and inspect for any damage that may had occurred during transportation to LDRS.

2.   _____Verify that all of the needed equipment is in hand.

 Flight Day Check List
Done the morning of the flight

1.   ____ Assemble the motor per manufacture instruction.

2.   ____Double Check motor assembly for no missing pieces
and everything is secure.

3.   ____ Assemble the Main Pyro. Charges

4.   ____ Assemble the Drogue Pyro. Charges

5.   ____ Remove Electronics from payload section.

6.   ____ Check all wiring for lose or broken connections.

7.   ____ Check voltage on two new 9 volt batteries.

8.   ____ Install and secure two 9 volt batteries on the sled.

9.   ____ Test both altimeters.

10. ____ Verify the settings on both altimeters.

11.    ____ Double check power switches are off. Reinstall Recovery electronics

12.    ____ Install the Main Pyro. Charges

13.    ____ Install The Drogue Pyro. Charges

14.    ____ Secure Electronic sled in the electronic bay.

15.    ____ Close up the Electronic bay.

16.    ____ Check for continuity on both Pyro Charges.

17.    ____  Attach the main recovery shock cord to the U bolt on the forward bulk head.

18.    ____ Attach the main body tube to electronic bay and secure with screws.

19.    ____ Attach the Nomex pad to shock cord.

20.    ____ Attach the main shock cord to the nosecone

21.    ____ Pack the main parachute.

22.    ____ Attach the main parachute  to the shock cord.

23.    ____ place the main parachute in the main body tube.

24.    ____ Place nosecone on the body tube and secure with shear pins.

25.    ____ Attach drogue shock cord to the aft end of the electronic bay.

26.    ____ Attach the drogue body tube to the electronics bay and secure with screws.

27.    ____ Attach the drogue shock cord to the bulkhead on the booster section.

28.    ____ Pack drougue parachute.

29.    ____attachNomex pad

30.    ____ attach Drougue parachute to shock cord.

31.    ____ connect the booster to the drogue section of body tube.

32.    ____ secure with shear pins.

33.    ____ Install the Motor into the booster.

34.    ____ Secure Motor in place with clips and screws.

35.    ____ Fill out flight card, get pad assignment.

36.    ____  Take rocket out to the pads.

37.    ____ Load rocket on the launch rail.

38.    ____ Install ignitor.

39.    ____ Arm both altimeters.

40.    ____ Verify the correct beep patterns.

41.    ____ Take pictures.

42.    ____ Request LCO launch rocket.

43.    ____ Go recover rocket.

44.    ____ Get Level 3 paperwork signed.

45.    ____ Party!